Setting Triggers For Devices - Dell PowerConnect W-Airwave User Manual

Figure 142 System > Triggers > Add Trigger Type Drop-down Menu
Once you have selected a trigger type, the Add Trigger page changes. In many cases, you must configure at least
one Condition setting. Conditions, settings, and default values vary according to trigger type. Triggers with
conditions can be configured to fire if any criteria match as well as if all criteria match.
Complete the creation of your trigger type using one of the following procedures for each trigger:
"Setting Triggers for Devices" on page 216

"Setting Triggers for Radios" on page 218

"Setting Triggers for Discovery" on page 220

"Setting Triggers for Users" on page 221

"Setting Triggers for RADIUS Authentication Issues" on page 222

"Setting Triggers for IDS Events" on page 223

"Setting Triggers for AWMS Health" on page 225


Setting Triggers for Devices

After completing steps 1-3 in
the configuration of device-related triggers.
a. If you have not already done so, choose a device type from the Devices listed in the Type drop-down
menu. See
216 | Performing Daily Administration in AWMS
"Creating New Triggers" on
Figure 142. Table 112 itemizes and describes device trigger options and condition settings.
page 214, perform the following steps to complete
Dell PowerConnect W AirWave 7.1 | User Guide