Dell PowerConnect W-Airwave User Manual page 217

Table 112 Device Trigger Types
Device Trigger Options
Device Down
Device Up
Configuration Mismatch
AP User Count
Dell PowerConnect W AirWave 7.1 | User Guide
Description
This is the default type whenever configuring a new trigger. This type of trigger activates
when an authorized, managed AP has failed to respond to SNMP queries from AWMS.
To set the conditions for this trigger type, click Add in the Conditions section. Complete the
conditions with the Option, Condition, and Value drop-down menus. The conditions establish
the device type. Multiple conditions can apply to this type of trigger. The Device Down trigger
can be configured to send alerts for thin APs when the controller is down; this behavior is
turned off by default.
This trigger type activates when an authorized, previously down AP is now responding to
SNMP queries.
To set the conditions for this trigger type, click Add in the Conditions section. Complete the
conditions with the Option, Condition, and Value drop-down menus. The conditions establish
the type that a device is or is not. Multiple conditions can apply to this type of trigger.
This trigger type activates when the actual configuration on the AP does not match the
defined Group configuration policy.
To set the conditions for this trigger type, click Add in the Conditions section. Complete the
conditions with the Option, Condition, and Value drop-down menus. The conditions establish
the type that a device is or is not. The conditions establish the type that a device is or is not.
Multiple conditions can apply to this type of trigger.
This trigger type activates when the user count on a given AP device reaches a specific
threshold. The number of user devices associated to an AP has exceeded a predefined
threshold for more than a specified period, in seconds (such as more than 10 users
associated for more than 60 seconds). Selecting AP User Count displays an additional
Duration setting. Define the Duration, which can be expressed as hours, minutes, seconds, or
a combination of these. Click the Add New Trigger Condition button to create one or more
conditions for the User Count trigger.
Figure 143 Sample of Trigger Condition for AP Device User Count
Performing Daily Administration in AWMS | 217