Configuring Radius Authentication And Authorization - Dell PowerConnect W-Airwave User Manual

Configuring RADIUS Authentication and Authorization

For RADIUS capability, you must configure the IP/Hostname of the RADIUS server, the TCP port, and the
server shared secret. Perform these steps to configuration RADIUS authentication:
1. Navigate to the AMP Setup > Authentication page. This page displays current status of RADIUS.
illustrates this page when neither TACACS+ nor RADIUS authentication is enabled in AWMS.
Figure 30
2. Click No to disable or Yes to enable TACACS+ nor RADIUS authentication. If you click Yes, several new
fields appear. Complete the fields described in
Table 30 AMP Setup > Authentication Fields and Default Values
Field
Primary Server
Hostname/IP Address
Primary Server Port
Primary Server Secret
Secondary Server
Hostname/IP Address
Secondary Server Port
Secondary Server Secret N/A
3. Click Save to retain these configurations, and continue with additional steps in the next procedure.
64 | Configuring AWMS
Setup > Authentication Page Illustration
AMP
Default
N/A
49
N/A
N/A
49
Table 30.
Description
Enter the IP address or the hostname of the primary RADIUS server.
Enter the TCP port for the primary RADIUS server.
Specify the primary shared secret for the primary RADIUS server, and confirm in
the Confirm field.
Enter the IP address or the hostname of the secondary RADIUS server.
Enter the TCP port for the secondary RADIUS server.
Enter the shared secret for the secondary RADIUS server.
Dell PowerConnect W AirWave 7.1 | User Guide
Figure 30