Dell PowerConnect W-Airwave User Manual page 105

11. To configure Colubris-only settings in this device group, locate the Colubris section and define the required
fields.
Table 68 Colubris-only Fields and Default Values
Setting
Rogue Scanning
Rogue Scanning Interval
(10-600 secs)
Automatic Channel Interval
First Radio
Second Radio
(CN330 only)
12. To configure Symbol-only settings, locate the Symbol section and define the required fields.
describes the settings and default values.
Table 69 Symbol-only Fields and Default Values
Setting
Rogue Scanning
Rogue Scanning Interval (5-
480 min)
13. To configure Enterasys R2 settings, locate the Enterasys R2 section and define the required fields.
describes the settings and default values.
Table 70 Enterasys Section Fields and Default Values
Setting
Operational Mode
14. Click Save when radio configurations as described above are complete, or click Save and Apply to retain
changes and push them to network devices. Click Revert to return to the last saved changes.
Dell PowerConnect W AirWave 7.1 | User Guide
Table 68 describes the settings and default values.
Default
Yes
600
12 Hours
802.11b only
1 Mbps
802.11b only
1 Mbps
Default
Yes
240
Default
802.11b +
802.11g
Description
If enabled, Colubris access points in the group will passively scan for rogue access
points at the specified interval. This rogue scan will not break a user's association
to the network.
If rogue scanning is enabled, this setting controls the frequency with which scans
are conducted (in minutes). Frequent scans provide the greatest security, but AP
performance and throughput available to user devices may be impacted modestly
during a rogue scan.
Sets the frequency by which APs monitor radio channels for availability and
activity.
Sets the operational mode and multicast data rate for the first Colubris radio.
Sets the operational mode and multicast data rate for the second Colubris radio,
supported only for the Colubris CN330.
Description
If enabled, Symbol access points with 3.9.2 or later firmware in the group will
passively scan for rogue access points at the specified interval. This rogue scan
will not break a user's association to the network.
If rogue scanning is enabled, this setting controls the frequency with which scans
are conducted (in minutes). Frequent scans provide the greatest security, but AP
performance and throughput available to user devices may be impacted modestly
during a rogue scan.
Description
Drop-down menu defines the 802.11 settings to support with the Enterasys radio
devices in this group. Supported options are as follows:
802.11a only

802.11b only

802.11g only

802.11b + 802.11g

Configuring and Using Device Groups in AWMS |
Table 69
Table 69
105