Configuring Cisco Router And Switch Interface Settings; Individual Device Support And Firmware Upgrades - Dell PowerConnect W-Airwave User Manual

Configuring Cisco Router and Switch Interface Settings

When you select an interface on a Cisco wired device to edit in AWMS, the fields available in the virtual or
physical Interface Configuration pane will auto-populate according to the existing interface device configuration
as shown in Figure 117.
Figure 117 Physical Interfaces Configuration Pane (Interfaces Monitoring and Configuration Window)
Not all interface settings are valid for all switches. You can change or overwrite any of the pre-populated settings
as well as revise or add to the Additional Commands fields to tailor the template configuration to the needs of
your production environment. For further details and assistance with settings configuration, refer to your Cisco
product documentation.
AWMS assembles the entire running configuration using templates and your modifications to these pages. For a
more detailed discussion on the use of templates, see Chapter 6, "Creating and Using Templates" on page 175.

Individual Device Support and Firmware Upgrades

Perform the following steps to configure AP communication settings for individual device types.
1. Locate the Device Communication area on the APs/Devices > Manage page.
2. Specify the credentials to be used to manage the AP. Figure 118 illustrates this page.
Dell PowerConnect W AirWave 7.1 | User Guide Discovering, Adding, and Managing Devices | 169