Defining A Snmp/Http Scan Set - Dell PowerConnect W-Airwave User Manual

5. Define and confirm the Community String to be used during scanning. In this section, the community string
used can be either read-only or read/write, as AWMS only uses it for discovering APs. To bring APs under
management, AWMS uses the credentials supplied in the Device Setup > SNMP page.
Note: AWMS automatically appends the type of scan (SNMP or HTTP) to the Label.
6. Click Add. The Device Setup > Discover page displays the new scan credential or credentials just created or
edited.
7. Repeat these steps to add as many credentials as you require.
8. Once scan networks and scan credentials are defined, combine them by creating scan sets using the next
procedure titled

Defining a SNMP/HTTP Scan Set

Once you have defined at least one network and one scan credential, you can create a scan set that combines the
two for device discovery. Perform these steps to create a scan set.
1. Locate the Scan Set area at the top of the Device Setup > Discover page.
illustrates this page. The Scan Set pane is illustrated in
Figure 78 Device Setup > Discover > Scan Sets Section Illustration
2. Click Add New Scan Set, and the Scan Set section displays. Below the Scan Set section, the Networks and
Credentials sections display all scan components configured so far. If you wish to create a new network, or
new scanning credentials, you can click Add in either of these fields to create new components prior to
creating a scan set.
130 | Discovering, Adding, and Managing Devices
"Defining a SNMP/HTTP Scan Set" on
illustrates the Add New Scan Set page.
Figure 79
page 130.
Figure
Figure 78.
Dell PowerConnect W AirWave 7.1 | User Guide
75, shown previously,