This appendix includes the following sections:
"Prerequisites for Integrating AWMS with Cisco Clean Access" on page 317
"Adding AWMS as RADIUS Accounting Server" on page 317
"Configuring Data in Accounting Packets" on page 317
Prerequisites for Integrating AWMS with Cisco Clean Access
Run Clean Access Software 3.5 or higher
Run AWMS version 3.4.0 or higher
Complete of the
Adding AWMS as RADIUS Accounting Server
Perform these steps to configure Cisco Clean Access integration:
1. Log in to the clean machine server and navigate to the User Management > Accounting > Server Config
page.
Select Enable RADIUS Accounting.
Input the AWMS Hostname or IP Address.
For Timeout (sec) - leave default 30.
Ensure the Server Port is set for 1813.
Ensure that the input Shared Secret matches the AWMS shared secret.
2. Select Update button to save.
Configuring Data in Accounting Packets
1. Navigate to User Management > Accounting > Shared Events.
2. Map the following attributes to corresponding data elements as seen in the graphic:
Framed_IP_Address = "User IP"
User_Name = "LocalUser"
Calling_Station_ID = "User MAC"
Note: These attribute element pairs are mandatory for username display within AWMS.
Dell PowerConnect W AirWave 7.1 | User Guide
AMP SETUP > RADIUS Accounting
Appendix E
Cisco Clean Access Integration
(Perfigo)
section on
AMP
Cisco Clean Access Integration (Perfigo) |
317