Dell PowerConnect W-Airwave User Manual page 85

Table 38 Basic and Global Group Fields and Default Values
Setting
Name
Missed SNMP
Poll Threshold
Regulatory
Domain
Timezone
Allow One-to-
One NAT for
Groups
Audit
Configuration on
Devices
Global Groups
4. Complete the SNMP Polling Periods section. The information in this section overrides default settings.
Table 39
Table 39 SNMP Polling Period Fields and Default Values
Setting
Up/Down Status Polling
Period
Override Polling Period for
Other Services
User Data Polling Period
Thin AP Discovery Polling
Period
Device-to-Device link Polling
Period
Device Bandwidth Polling
Period
802.11 Counters Polling Period 5 minutes
Rogue AP and Device
Location Data Polling Period
Dell PowerConnect W AirWave 7.1 | User Guide
Default Description
Defined when Displays or changes the group name. As desired, use this field to set the user-definable
first adding the name to uniquely identify the group by location, vendor, department, or any other
group identifier (such as "Accounting APs," "Floor 1 APs," "Cisco devices," "802.1x APs," and
so forth).
1 Sets the number of Up/Down SNMP polls that must be missed before AWMS considers a
device to be down. The number of SNMP retries and the SNMP timeout of a poll can be
set on the Device Setup > Communication page.
United States Sets the regulatory domain in AWMS, limiting the selectable channels for APs in the
group.
AMP System Allows group configuration changes to be scheduled relative to the time zone in which
Time the devices are located. This setting is used for scheduling group-level configuration
changes.
No Allows AWMS to talk to the devices on a different IP address than the one configured on
the device.
NOTE: If enabled, the LAN IP Address listed on the AP/Devices > Manage configuration
page under the Settings area is different than the IP Address under the Device
Communication area.
Yes Auditing and pushing of configuration to devices can be disabled on all the devices in
the group. Once disabled, all the devices in the groups will not be counted towards
mismatched devices.
No When enabled, this field allows you to define the device group to be a global group.
Refer also to
describes the SNMP polling settings.
Default
5 minutes
No
5 minutes
5 minutes
5 minutes
5 minutes
5 minutes
"Using Global Groups for Group Configuration" on
Description
Sets time between Up/Down SNMP polling for each device in the group.
The Group SNMP Polling Interval overrides the global parameter configured on
the Device Setup > Communication configuration page. Aruba recommends an
initial polling interval of 5 minutes for most networks.
Radio button enables or disables overriding the base SNMP Polling Period. If you
select Yes for this field, then the other settings in the SNMP Polling Periods
section are activated, and you can override default values.
Sets time between SNMP polls for User Data for devices in the group.
Sets time between SNMP polls for Thin AP Device Discovery. Controllers are the
only devices affected by this polling interval.
Sets time between SNMP polls for Device-to-Device link polling. Mesh APs are
the only devices affected by this polling interval.
Sets the interval at which AWMS polls for the bandwidth being used by a device.
Sets time between SNMP polls for 802.11 Counter information.
Sets time between SNMP polls for Rogue AP and Device Location Data polling.
Configuring and Using Device Groups in AWMS |
page 125.
85