Dell PowerConnect W-Airwave User Manual page 45

Table 13 AMP Setup > General > Default Firmware Upgrade Options Fields and Default Values
Setting
Simultaneous Devices
per Job
(1-1000)
Failures Before
Stopping (0-20)
8. On the AMP Setup > General page, locate the Additional AMP Services section, and adjust settings as
required.
Table 14 AMP Setup > General > Additional AMP Services Fields and Default Values
Setting
Enable FTP Server
Enable RTLS Collector
Use Embedded Mail
Server
Process User Roaming
Traps from Cisco WLC
Enable AMON data
collection
9. On the AMP Setup > General page, locate the Performance Tuning section. Performance tuning is unlikely
to be necessary for many AWMS implementations, and likely provides the most improvements for customers
with extremely large Pro or Enterprise installations. Please contact Dell support if you think you might need to
change any of these settings.
Table 15 AMP Setup > General > Performance Tuning Fields and Default Values
Setting
Monitoring
Processes
Dell PowerConnect W AirWave 7.1 | User Guide
Default Description
20 Defines the number of devices that can be in the process of upgrading at the same time.
AWMS only runs one TFTP transfer at a time. As soon as the transfer to a device has
completed, the next transfer begins, even if the first device is still in the process of
rebooting or verifying configuration.
1 Sets the default number of upgrade failures before AWMS pauses the upgrade process.
User intervention is required to resume the upgrade process. Setting this value to 0
disables this function.
Table 14 describes the settings and default values of this section.
Default Description
No Enables or disables the FTP server on AMP. The FTP server is only used to manage Cisco
Aironet 4800 APs. Aruba recommends disabling the FTP server if you do not have any
Cisco Aironet 4800 APs in the network.
No Enables or disables the RTLS Collector, which is used to allow AOS controllers to send
RTLS packets to VisualRF. The RTLS server IP address must be configured on each
controller. This function is used for VisualRF to improve location accuracy and to locate
chirping asset tags. This function is supported only for Dell PowerConnect W and Aruba
devices.
With selection of Yes, the following additional fields appear:



Yes Enables or disables the embedded mail server that is included with AWMS.
This field supports a Send Test Email button for testing server functionality. Clicking this
button prompts you with a To and From field in which you must enter valid email
addresses, and a button to send a test email.
Yes AMP now parses client association and authentication traps from Cisco WLC controllers
to give real time information on users connected to the wireless network.
Yes Allows AMP to collect enhanced data from Aruba devices on certain firmware versions;
see the Aruba Best Practices Guide for more details.
Table 15
Default
Based on the number
of cores for your
server
RTLS Port—Specify the port for the RTLS server.
RTLS Username—Enter the user name supported by the RTLS server.
RTLS Password—Enter the RTLS server password.
describes the settings and default values of this section.
Description
Optional setting configures the throughput of monitoring data. Increasing this
setting allows AWMS to process more data per second, but it can take
resources away from other AWMS processes. Please contact Dell support if
you think you might need to increase this setting for your network.
Configuring AWMS | 45