Dell PowerConnect W-Airwave User Manual page 96

Table 55 Groups > SSIDs > SSID/VLAN Section Fields and Default Values (Continued)
Setting
Name
VLAN ID
Service Priority
(Cisco VxWorks only)
Maximum Allowed
Associations (0-2007)
Broadcast SSID (Proxim
only)
Partial Closed System
(Proxim only)
Unique Beacon
(Proxim only)
Block All Inter-client
Communication
5. Locate the Encryption area on the Groups > SSIDs page and adjust these settings as required.
describes the settings and default values.
Table 56 Groups > SSIDs > Encryption Section Fields and Default Values
Setting
Encryption Mode
6. Locate the EAP Options area on the Groups > SSIDS page, and complete the settings.
Table 57
96 | Configuring and Using Device Groups in AWMS
Default
None
None
None
255
No
No
No
Yes
Default Description
No Encryption Drop-down menu determines the level of encryption required for devices to associate
to the APs. The drop-down menu options are as follows. Each option displays
additional encryption settings that must be defined. Complete the associated settings
for any encryption type chosen:











describes the settings and default values.
Description
Sets a user-definable name associated with SSID/VLAN combination.
Indicates the number of the VLAN designated as the Native VLAN, typically for
management purposes
Identifies the delivery priority which packets receive on the VLAN/SSID
(VxWorks only).
Indicates the maximum number of mobile users which can associate with the
specified VLAN/SSID.
NOTE: 0 means unlimited for Cisco and none for Colubris.
For specific devices as cited, this setting enables the AP to broadcast the
SSID for the specified VLAN/SSID. This setting works in conjunction with the
Create Closed Network setting on the Groups> Security configuration page.
Proxim devices support a maximum of four SSIDs.
NOTE: This option should be enabled to ensure support of legacy users.
For Proxim only, this setting enables to AP to send its SSID in every beacon,
but it does not respond to any probe requests.
For Proxim only, if more than one SSID is enabled, this option enables them to
be sent in separate beacons.
For Colubris only, this setting blocks communication between client devices
based on SSID.
Optional WEP—Wired Equivalent Privacy, not PCI compliant as of 2010
Require WEP—Wired Equivalent Privacy, not PCI compliant as of 2010
Require 802.1x—This encryption type is based on the WEP algorithm.
Require Leap—Lightweight Extensible Authentication Protocol
802.1x+WEP—Combines the two encryption types shown
LEAP+WEP—Combines the two encryption types shown
Static CKIP—Cisco Key Integrity Protocol
WPA—Wi-Fi Protected Access protocol
WPA/PSK—Combines WPA with Pre-Shared Key encryption
WPA2—Wi-Fi Protected Access 2 encryption
WPA2/PSK—Combines the two encryption methods shown
Dell PowerConnect W AirWave 7.1 | User Guide
Table 56