Grouping
WDS Participation
Primary or Secondary WDS
Adding an ACS Server for WLSE
1. Navigate to the Devices > Discover > AAA Server page.
2. Select New from the drop-down list.
3. Enter the Server Name, Server Port (default 2002), Username, Password, and Secret.
4. Click Save.
Enabling Rogue Alerts for Cisco WLSE
1. Navigate to the Faults > Network Wide Settings > Rogue AP Detection page.
2. Select the Enable toggle.
3. Click Apply.
Additional information about rogue device detection is available in
on page
Configuring WLSE to Communicate with APs
1. Navigate to the Device Setup > Discover page.
2. Configure SNMP Information.
3. Configure HTTP Information.
4. Configure Telnet/SSH Credentials.
5. Configure HTTP ports for IOS access points.
6. Configure WLCCP credentials.
7. Configure AAA information.
Discovering Devices
There are three methods to discover access points within WLSE, as follows:
Using Cisco Discovery Protocol (CDP)
Importing from a file
Importing from CiscoWorks
Perform these steps to discover access points.
1. Navigate to the Device > Managed Devices > Discovery Wizard page.
2. Import devices from a file.
3. Import devices from Cisco Works.
4. Import using CDP.
Managing Devices
Prior to enabling radio resource management on IOS access points, the access points must be under WLSE
management.
Note: AWMS becomes the primary management/monitoring vehicle for IOS access points, but for AWMS to gather Rogue
information, the WLSE must be an NMS manager to the APs.
Dell PowerConnect W AirWave 7.1 | User Guide
69.
"Configuring Cisco WLSE Rogue Scanning"
Configuring AWMS |
67