Defining And Configuring Lwapp Ap Groups For Cisco Devices; Viewing And Creating Ap Groups; Configuring Cisco Controller Settings - Dell PowerConnect W-Airwave User Manual

Defining and Configuring LWAPP AP Groups for Cisco Devices

The Groups > Cisco WLC Config > WLANs > Advanced > AP Groups page allows you to add/edit/delete AP
Groups on the Cisco WLC. LWAPP AP Groups are used to limit the WLANs available on each AP. Cisco thin
APs are assigned to LWAPP AP Groups.

Viewing and Creating AP Groups

1. Go to the Groups > Cisco WLC Config page, and select WLANs > Advanced > AP Groups in the
navigation pane at left. This page displays the configured LWAPP APs.
Figure 50 Groups > Cisco WLC Config > WLANS > Advanced > AP Groups Page Illustration
2. To add a new LWAPP AP group, select Yes in the AP Groups section. Additional controls appear.
3. Select Add to create a new LWAPP AP group. To edit an existing LWAPP AP group, select the pencil icon
next to that group. Add one or more SSIDs and the interface/VLAN ID mapping on the Add/Edit page of the
LWAPP AP Group.
4. Select Save and Apply to make these changes permanent, or select Save to retain these changes to be pushed
to controllers at a later time.

Configuring Cisco Controller Settings

The Groups > Cisco WLC Config > Controller page defines general Cisco WLC settings, Multicast settings,
Cisco mobility groups to be supported on Cisco controllers, Network Transfer Protocol (NTP), and Spanning
Tree Protocol settings.
Go to the Groups > Cisco WLC Config > Controller page. This navigation is illustrated in
Figure 51 Groups > Cisco WLC Config > Controller Navigation
Dell PowerConnect W AirWave 7.2 | User Guide
Figure 50 illustrates this page.
Configuring and Using Device Groups in AWMS | 95
Figure 51.