Viewing And Adding Templates - Dell PowerConnect W-Airwave User Manual

Viewing and Adding Templates

Perform these steps to display, add, or edit templates.
1. Navigate to the Groups > List page, and select a group for which to add or edit templates. This can be a new
group, created with the Add button, or you can edit an existing group by clicking the corresponding pencil
icon. The Groups > Basic page for that group appears.
Additional information about adding and editing groups is described in
Groups in AWMS" on
2. From the AWMS navigation pane, click Templates. The Templates page appears.
Groups > Templates configuration page, and
Figure 123 Groups > Templates Page Illustration for a Sample Device Group
Table 93 Groups > Templates Fields and Default Values
Setting
Notes
Name
Device Type
Dell PowerConnect W AirWave 7.1 | User Guide
page 79.
Description
When applicable, this section lists devices that are active on the network with no template available for
the respective firmware. Click the link from such a note to launch the Add Template configuration page for
that device.
Displays the template name.
Displays the template that applies to APs or devices of the specified type. If vendor (Any Model) is
selected, the template applies to all models from that vendor that do not have a version specific template
defined. If there are two templates that might apply to a device, the template with the most restrictions
takes precedence.
"Configuring and Using Device
Table 93 describes the information columns.
Figure 123 illustrates the
Creating and Using Templates | 177