Configuring Group Security Settings - Dell PowerConnect W-Airwave User Manual

Configuring Group Security Settings

The Groups > Security page allows you to set security policies for APs in a device group. Perform these steps.
1. Select the device group for which to define security settings from the Groups > List page.
2. Select the Groups > Security page. Some controls on this page interact with additional AWMS pages.
43 illustrates this page and
Figure 43 Groups > Security Page Illustration
Table 53 Groups > Security Page Fields and Default Values
Setting
VLANs Section
VLAN Tagging and Multiple
SSIDs
Management VLAN ID
Dell PowerConnect W AirWave 7.1 | User Guide
Table 53 explains the fields and default values.
Default Description
Enabled This field enables support for VLANs and multiple SSIDs on the wireless network. If
this setting is enabled, define additional VLANs and SSIDs on the Groups > SSIDs
page. Refer to "Configuring Group SSIDs and VLANs" on
Untagged This setting sets the ID for the management VLAN when VLANs are enabled in
AWMS. This setting is supported only for the following devices:
Proxim AP-600, AP-700, AP-2000, AP-4000

Avaya AP-3, Avaya AP-7, AP-4/5/6, AP-8

ProCurve520WL; ProCurve420

Enterasys AP3000

page 94.
Configuring and Using Device Groups in AWMS |
Figure
91