Dell PowerConnect W-Airwave User Manual page 88

11. To configure settings specific to Cisco WLC, locate the Cisco WLC section and adjust these settings as
required.
Table 45 Cisco WLC Fields and Default Values
Setting
SNMP Version
CLI Communication
Note: When configuring Cisco WLC controllers, refer also to
page 110.
12. To configure Proxim/Avaya specific settings locate the Proxim/Avaya section and adjust these settings as
required.
Table 46 Proxim/Avaya Fields and Default Values
Setting
SNMP Version
Enable DNS
Client
Primary DNS
server
Secondary DNS
server
Default DNS
domains
HTTP Server Port 80
Country Code
13. To configure HP ProCurve 420 specific settings, locate the HP ProCurve 420 section and adjust these settings
as required.
Table 47 HP ProCurve 420 Fields and Default Values
Setting
SNMP Version
ProCurve XL/ZWeSM CLI
Communication
88 | Configuring and Using Device Groups in AWMS
Table 45 describes the settings and default values.
Default Description
2c Drop-down menu specifies the version of SNMP used by AWMS to communicate to
WLC controllers.
Telnet Sets the protocol AWMS uses to communicate with Cisco IOS devices. Selecting SSH
uses the secure shell for command line page (CLI) communication. Selecting Telnet
sends the data in clear text via Telnet.
Table 46 describes the settings and default values.
Default Description
1 Drop-down menu specifies the version of SNMP used by AWMS to communicate to the
AP.
No Enables the DNS client on the AP. Enabling the DNS client allows you to set some values
on the AP by hostname instead of IP address. If you select Yes for this setting, additional
DNS fields display.
Blank Sets the IP address of the Primary DNS server.
Blank Sets the IP address of the Secondary DNS server.
Blank Sets the default DNS domain used by the AP.
AWMS sets this port as the HTTP server port on all Proxim APs in the group.
United States Configures AWMS to derive its time settings based on the country of location, as
specified in this field.
Table 47 describes the settings and default values.
Default Description
2c Drop-down menu specifies the version of SNMP used by AWMS to communicate to the
AP.
Telnet Sets the protocol AWMS uses to communicate with ProCurve XLWeSM devices.
Selecting SSH will use the secure shell for command line page (CLI) communication.
Selecting telnet will send the data in clear text via telnet.
"Configuring Wireless Parameters for Cisco Controllers" on
Dell PowerConnect W AirWave 7.1 | User Guide