Important Points To Remember; Configuring Eis; Management Interfaces; Configuring Management Interfaces - Dell Force10 Z9000 Configuration Manual

EIS: DNS, FTP, NTP, RADIUS, sFlow, SNMP, SSH, Syslog, TACACS, Telnet, and TFTP. This feature does not support sFlow on
stacked units.
When you enable this feature, all management routes (connected, static, and default) are copied to the management EIS routing
table. Use the management route command to add new management routes to the default and EIS routing tables. Use the show
ip management-eis-route command to view the EIS routes.

Important Points to Remember

• Deleting a management route removes the route from both the EIS routing table and the default routing table.
• If the management port is down or route lookup fails in the management EIS routing table, the outgoing interface is selected
based on route lookup from the default routing table.
• If a route in the EIS table conflicts with a front-end port route, the front-end port route has precedence.
• Due to protocol, ARP packets received through the management port create two ARP entries (one for the lookup in the EIS
table and one for the default routing table).

Configuring EIS

EIS is compatible with the following protocols: DNS, FTP, NTP, RADIUS, sFlow, SNMP, SSH, Syslog, TACACS, Telnet, and TFTP.
To enable and configure EIS, use the following commands:
1. Enter EIS mode.
CONFIGURATION mode
management egress-interface-selection
2. Configure which applications uses EIS.
EIS mode
application {all | application-type}
NOTE: If you configure SNMP as the management application for EIS and you add a default management route,
when you perform an SNMP walk and check the debugging logs for the source and destination IPs, the SNMP agent
uses the destination address of incoming SNMP packets as the source address for outgoing SNMP responses for
security.

Management Interfaces

The system supports the Management Ethernet interface as well as the standard interface on any port. You can use either method
to connect to the system.

Configuring Management Interfaces

The dedicated Management interface provides management access to the system.
You can configure this interface with Dell Networking OS, but the configuration options on this interface are limited. You cannot
configure Gateway addresses and IP addresses if it appears in the main routing table of Dell Networking OS. In addition, proxy ARP is
not supported on this interface.
To configure a management interface, use the following commands.
• Enter the slot and the port (0) to configure a Management interface.
CONFIGURATION mode
interface managementethernet interface
The slot range is 0.
• Configure an IP address and mask on a Management interface.
INTERFACE mode
ip address ip-address mask
283
Interfaces