When The Data In Indicator Does Not Light Up Or Flash - Ricoh SP 5200S Operating Instructions Manual

Problem
Data In indicator does not
light up or flash.
[List / Test Print] is disabled.
Printing does not start when
using the extended wireless
LAN in Ad-hoc mode.
If printing does not start, contact your service representative.

When the Data In Indicator Does Not Light Up or Flash

When the Data In indicator does not light up or flash after starting a print job, data is not being sent to
the machine.
When the machine is connected to the computer using the interface cable
This section describes how to check the print port when the Data In indicator does not light up or blink.
Check if the print port setting is correct.
Causes
If the Data In indicator does
not light up or flash even
after the print job starts, the
machine has not received
the data.
A mechanical error might
have occurred.
The correct Communication
mode is not set.
When You Cannot Print
Solutions
• When the machine is connected
to a computer via a cable, check
the computer print port settings
are correct. For details, see p.
93 "When the Data In Indicator
Does Not Light Up or Flash".
• When it is networked with a
computer, contact your
administrator.
Contact your service representative.
• Turn off the main power switch,
and then back on again. See
"Turning On/Off the Power",
About This Machine.
• In [System Settings], under
[Interface Settings], select
[Wireless LAN], and then set
[Communication Mode] to
[802.11 Ad-hoc Mode] and
[Security Method] to [Off]. Then
at the other side, set [SSID
Setting] and [Ad-hoc Channel] to
the same values.
4
93