Ricoh SP 5200S Operating Instructions Manual page 81

Message
"Hardware Problem: HDD"
"Hardware Problem: USB"
"Hardware Problem:
Wireless Board"
"Hardware Problem:
Wireless Card"
"Load following paper in n.
To cancel job, press [Job
Reset]."
(A figure is placed at n.)
"More than one file cannot
be selected with this file
type."
Causes
An error has occurred in the
hard disk.
An error has occurred in the
USB interface.
Access to the wireless board
in which the wireless LAN
board is inserted is possible,
but an error was detected.
• The installed wireless
LAN card is not
compatible with this
machine.
• An error has occurred
in the wireless LAN
card.
The printer driver settings are
incorrect or the tray does not
contain paper of the size
selected in the printer driver.
A non-JPEG file has been
selected.
Messages Displayed When Using the Printer Function
Solutions
Turn off the main power switch, and
then back on again. If the message
appears again, contact your service
representative.
Turn off the main power switch, and
then back on again. If the message
appears again, contact your service
representative.
Turn off the main power switch, and
then check the wireless board is
inserted correctly. And then, turn on the
main power switch again. If the
message appears again, contact your
service representative.
Turn off the main power switch, and
then check the wireless card. And then,
turn on the main power switch again. If
the message appears again, contact
your service representative.
Check that the printer driver settings
are correct, and then load paper of the
size selected in the printer driver into
the input tray. For details about how to
change the paper size, see "Changing
the Paper Size", About This Machine.
Multiple non-JPEG files cannot be
selected at one time in the Direct
printing function from removable
memory devices. Select files
separately.
4
79