Ricoh SP 5200S Operating Instructions Manual page 103

Problem
Edges of sheets are creased. You are using non-
Duplex printing is
malfunctioning.
Duplex printing is
malfunctioning.
Duplex printing is
malfunctioning.
The image on the back side
of duplex prints has mottled
blank patches or is
smudged.
White stripes appear on the
OHP.
Causes
recommended paper.
You have loaded thin paper
2
lighter than 60 g/m (16 lb.
Bond), or thick paper
2
heavier than 163 g/m (90
lb. Index).
"Apply Duplex" is set to [No]
for "Paper Type".
You have selected a paper
type that cannot be used for
duplex print.
Missing patches and
smudges are caused by
moisture leaking from the
paper.
Fragments of paper are
stuck to the OHP.
Other Printing Problems
Solutions
Use recommended paper. See
"Recommended Paper Sizes and
Types", About This Machine.
Change the paper.
In [Tray Paper Settings], under "Paper
Type" set "Apply Duplex" to [Yes]. For
details, see "Tray Paper Settings",
Network and System Settings
Reference.
In [Tray Paper Settings], select a paper
type that can be used for duplex print.
For details about the paper types that
can be used, see "Specifications for the
Main Unit", About This Machine.
• Do not install the machine in
areas that are susceptible to low
temperature.
• Use paper that has been stored
where temperature and humidity
conditions meet the limitations we
recommend. For details about the
paper storage conditions we
recommend, see "Paper Storage",
About This Machine.
Use a dry cloth to wipe any paper
fragments off the back of the OHP.
4
101