Table 6-53. Crtc Register Settings - AMD Geode LX 600@0.7W Data Book

Table of Contents

Display Controller Register Descriptions

VGA CRT Controller Registers

The CRTC registers are accessed by writing an index value to the CRTC Index register (3B4h or 3D4h) and reading or writ-

ing the register using the CRTC Data register (3B5h or 3D5h). See the description of the I/O Address Select bit in the Mis-

cellaneous Output register (Section 6.6.17.1 on page 356) for more information on the I/O address of the CRTC registers.

The CRT timings are controlled by the CRT Controller registers when the VGA is active. Various third-party VGA adapters

implement these registers differently, and so different cards can produce different timings with the same settings. The set-

tings shown in Table 6-53 are recommended for various VGA modes when programming the CRTC registers.

Note: The Extended VGA Registers are accessed through the CRTC interface. This section only discusses the base VGA

registers, however. See Section 6.6.23 "VGA Block Extended Registers" on page 384 for more information on the

extended registers.

AMD Geode™ LX Processors Data Book

Table 6-53. CRTC Register Settings

Show Quick Links

Table of Contents