Siemens MC55 Command Set page 331

MC55 AT Command Set
12.11 AT+CNMI
URC 3
=2 (text mode enabled):
<mt>
+CMT: <oa>, <scts>[, <tooa>, <fo>, <pid>, <dcs>, <sca>, <tosca>,
<length>]
<CR><LF>
Indicates that new message has been received
URC 4
=2 (PDU mode enabled):
<bm>
+CBM: <length>
<CR><LF>
Indicates that new cell broadcast message has been received
URC 5
=2 (text mode enabled):
<bm>
+CBM: <sn>, <mid>, <dcs>, <page>,
Indicates that new cell broadcast message has been received
URC 6
=1 (PDU mode enabled):
<ds>
+CDS: <length>
<CR><LF>
Indicates that new SMS status report has been received
URC 7
=1 (text mode enabled):
<ds>
+CDS: <fo>, <mr>[, <ra>][, <tora>], <scts>, <dt>,
Indicates that new SMS status report has been received
URC 8
=2:
<ds>
+CDSI: <mem3>, <index>
Indicates that new SMS status report has been received
Command Description
The write command selects the procedure how the receipt of new SMS messages from the network is indicated
to the TE when TE is active, e.g. DTR signal is ON. If TE is inactive (e.g. DTR signal is OFF), message receiving
should be done as specified in GSM 03.38. If the DTR signal is not available or the state of the signal is ignored
(V.25ter command
AT&D
cedure. The rules =2 and
<mt>
vated with =1. The parameter
AT+CSMS
Parameter Description
(num)(&W)
<mode>
(&F)
[0]
1
MC55_ATC_V01.05
Confidential / Released
<data>
<pdu>
<pdu>
0, reliable message transfer can be assured by using
=3 for storing received SM are possible only if phase 2+ compatibility is acti-
<mt>
=1 is only available in phase 2+
<ds>
Buffer unsolicited result codes in the TA. If TA result code buffer is full, indica-
tions can be buffered in some other place or the oldest indications may be dis-
carded and replaced with the new received indications.
Discard indication and reject new received message unsolicited result codes
when TA-TE link is reserved (e.g. in on-line data mode). Otherwise forward
them directly to the TE.
Page 331 of 469
<pages> <data>
<CR><LF>
<st>
s
m
obile
acknowledgment pro-
AT+CNMA
2/10/04