Table of Contents
Advertisement
MC55 AT Command Set
9.6 AT+CCFC
3
4
5
(num)
<mode>
network operation to be performed for Supplementary service "call forwarding"
0
1
2
3
4
(str)
<number>
string type phone number of forwarding address in format specified by
phone <number> will be registered in the network. This allows you to disable / enable CF to the same destination
without the need to enter the phone number once again. Depending on the services offered by the provider the
registration may be mandatory before CF can be used. The number remains registered in the network until you
register another number or erase it using <mode> = 4.
(num)
<type>
type of address octect
145
129
(num)
<class>
integer or sum of integers each representing a class of information, i.e. a bearer service, telecommunication ser-
vice or bearer service group as defined in "GSM 02.04"
1
2
4
8
16
32
64
128
1...[7]...255
MC55_ATC_V01.05
Confidential / Released
not reachable
all call forwarding (includes reasons 0, 1, 2 and 3)
all conditional call forwarding (includes reasons 1, 2 and 3)
disable call forwarding (disable service)
enable call forwarding (enable service)
query status of call forwarding (query service status)
register
and activate call forwarding (register service)
<number>
erase
and deactivate call forwarding (erase service)
<number>
dialling string
<number>
otherwise
voice
data
<class> 2 (data) comprises all those <class> values between 16 and 128, that
are supported both by the network and the MS. This means, a setting made for
<class> 2 applies to all remaining data classes (if supported). In addition, you
can assign a different setting to a specific class. For example, you can activate
Call Forwarding for all data classes, but deactivate it for a specific data class.
fax
SMS
data circuit sync
data circuit async
dedicated packet access
dedicated PAD access
combination of some of the above classes. For example, the default setting 7
represents the sum of the integers 1, 2 and 4 (CF for voice, data and fax). The
value 255 covers all classes. If the <class> parameter is omitted, the default
value 7 is used.
Page 223 of 469
. If you select
<type>
includes international access code character '+'
s
m
obile
= 3, the
<mode>
2/10/04
Advertisement
Table of Contents
