At^smong Cell Info Table - Siemens MC55 Command Set

MC55 AT Command Set
8.8 AT^SMONG
(num)
<period>
Display period in seconds
If is omitted the cell data will be presented only once on a single line (as if Execute command was
<period>
issued).
If is given, the cell data will be listed repeatedly on 10 data lines. Every 10
<period>
the header, simply to repeat the column titles.
1...100
Note
• For compatibility with earlier products and to support legacy applications, often any input character will stop
the periodic output of the write command. But since this applies only in certain cases (depending on the set-
tings of Chapter 4.7, page 96
8.8.1

AT^SMONG Cell Info Table

Example output for
AT^SMONG
GPRS Monitor
BCCH G PBCCH PAT MCC
0637 1 - 4
Columns of the cell info table:
Column Description
BCCH ARFCN of BCCH carrier
G GPRS supported (''1'') or not supported ''-''
PBCCH If PBCCH is present, indication of ARFCN, else ''-'' or if Frequency Hopping is used ''H''
PAT Priority Access Threshold (GSM Rec. 04.08 / 10.5.2.37b)
0 Packet access is not allowed in the cell
1 Spare, shall be interpreted as "000" (packet access not allowed)
2 Spare, shall be interpreted as "000" (packet access not allowed)
3 Packet access is allowed for priority level 1
4 Packet access is allowed for priority level 1 to 2
MCC Mobile Country Code
MNC Mobile Network Code
NOM Network Operation Mode (1...3)
TA Timing Advance Value
RAC Routing Area Code (as hexadecimal value)
MC55_ATC_V01.05
Confidential / Released
and Chapter 4.8, page
:
MNC NOM TA
234 05 2 00
Page 204 of 469
99), it is recommended to always use "at" or "AT".
RAC # Cell
0B
s
m
obile
th
data line is followed by
#
2/10/04