Siemens MC55 Command Set page 377

Hide thumbs Also See for MC55:
Table of Contents

Advertisement

MC55 AT Command Set
15.4 AT+CPBW
Parameter Description
(num)
<location>
Location number within phonebook memory. The supported range is given whith the test command response.
(str)
<number>
Phone number with format specified by
string. However, alphabetic characters are not permitted.
may contain printable non-alphabetic characters of the standard GSM alphabet as dialstring modifi-
<number>
ers, including "*", "#" or "+". However, if
straints shall be considered:
• If no
was specified explicitly, all accepted modifiers from the GSM alphabet will be saved in the num-
<type>
ber string.
will be set to 209 (ASCII). However, limitations as listed below for
<type>
• A
saved with
<number>
number needs to be reduced to a maximum length of
fiers. Extended locations may be used as stated below for
(num)
<type>
Type of address octet
If
is specified as 129 or 145, any non-digit characters other than "*", "#", or "+" will be removed from the
<type>
number string. If the number string contains such characters, they can be saved with the number string by using
209, see below.
<type>
145
209
129
(str)(+CSCS)
<text>
Text assigned to the phone number. The maximum length for this parameter is given in test command response
. When using an ASCII terminal, characters which are coded differently in ASCII and GSM have to
<tlength>
be entered via escape sequences as described in chapter
(num)
<maxloc>
Max. location for the currently selected storage. For phonebooks located on SIM, this value may vary between
SIM cards. See
AT+CPBS
(num)
<nlength>
Max. length of phone number for "normal" locations. - Depending on the storage, a limited number of locations
with extended memory is available per phonebook. These locations allow storing numbers with twice the stan-
dard length, which is 2*
<nlength>
with parameter
= 209. If all extended locations of the selected phonebook are used up, then any attempt
<type>
to write a number which requires extended memory will be denied with CME ERROR 260: INVALID DIAL
STRING.
MC55_ATC_V01.05
Confidential / Released
. Parameter must be present, although it may be an empty
<type>
contains modifiers other than "*", "#" or "+" the following con-
<number>
=209 requires double memory. In order to fit into a standard location, the
<type>
dialling string
<number>
dialling string
<number>
ters that should be saved with the number string. Remarks as under parameter
apply. For phonebook entries with this type, dialling from phone-
<number>
book with
ATD><mem><n>
otherwise
for typical values.
digits for normal numbers, but only
Page 377 of 469
/2, including all digits and dial string modi-
<nlength>
.
<nlength>
includes international access code character '+'
contains printable non-alphabetic non-digit charac-
is not possible.
Supported character sets
<nlength>
s
m
obile
209 apply.
<type>
.
digits for numbers saved
2/10/04

Advertisement

Table of Contents
loading

Table of Contents