Table of Contents
Advertisement
MC55 AT Command Set
11. FAX Commands
11.
FAX Commands
The following commands can be used for FAX transmission. If the ME is acting as a Fax-Modem to a PC-based
application (e.g. "WinFax") it is necessary to select the proper Service Class (Fax Class) provided by the ME.
The ME reports its Service Class capabilities, both the current setting and the range of services avaible. This is
provided by the
AT+FCLASS
Service Classes supported by ME:
Parameter
AT+FCLASS
0
1
2
The following AT commands are dummy commands:
AT+FAA Auto Answer mode
AT+FECM Error Correction Mode control
AT+FLNFC Page Length format conversion
AT+FLPL Indicate document available for polling
AT+FMINSP Minimum Phase C speed
AT+FRBC Phase C data receive byte count
AT+FREL Phase C received EOL alignment
AT+FSPL Enable polling
AT+FTBC Phase C data transmit byte count
AT+FWDFC Page width format conversion
Invoking these commands will not cause ERROR result codes, but these commands have no functionality.
11.1
FAX parameters
Parameter Description
(num)
<bf>
Binary File Transfer Mode
Note: Only the default value needs to be implemented. Use test command to check which parameter values are
really possible!
[0]
1
(num)
<br>
Bit Rate
0
1
2
[3]
MC55_ATC_V01.05
Confidential / Released
command.
Service class
data modem
Service Class 1
manufacture specific
disable BFT
enable BFT
2400 bit/s, V.27ter
4800 bit/s, V.27ter
7200 bit/s, V.29
9600 bit/s, V.29
Page 281 of 469
s
m
Reference, Standard
e.g. TIA/EIA-602 or ITU V.25ter
EIA/TIA-578-A
this document and EIA PN-2388
(draft)
obile
2/10/04
Advertisement
Table of Contents
