Summary Of At Commands Available In Alarm Mode; Table 17.1: List Of At Commands Available In Alarm And Charge-Only Mode - Siemens MC55 Command Set

MC55 AT Command Set
17.1 AT+CALA
EXAMPLE 2
To set a fresh alarm using the same message as in Example 1, simply enter date and time.
,
<text> <tlength>
AT+CALA="04/05/31,08:50:00"
OK
When the alarm is executed the URC comes with the same message:
+CALA: Good Morning
EXAMPLE 3
To configure the alarm mode, e.g. for May 20, 2004, at 8.30h, enter
AT+CALA="04/05/20,08:30:00"
OK
Next, power down the ME:
AT^SMSO
^SMSO: MS OFF
When the alarm is executed the ME wakes up to Alarm mode and displays a URC. If available, this line is
followed by the individual
appears.
^SYSSTART ALARM MODE
+CALA: Good Morning
17.1.1

Summary of AT commands available in Alarm mode

Table 17.1: List of AT Commands Available in Alarm and Charge-only Mode>
AT command
AT+CALA
AT+CCLK
AT^SBC
AT^SCTM
AT^SMSO
MC55_ATC_V01.05
Confidential / Released
can be omitted:
most recently saved. If no individual message was saved only the first line
<text>
Use
Set alarm time
Set date and time of RTC
In Alarm mode, you can query the present current consumption only and check
whether or not a charger is connected. The battery capacity is returned as 0,
regardless of the actual voltage (since the values measured directly on the cell are
not delivered to the module).
Query temperature of GSM engine
Power down GSM engine
Page 428 of 469
s
m
obile
, ,
<n> <type>
2/10/04