Table of Contents
Advertisement
MC55 AT Command Set
3.2 AT+CIND
"roam"
"smsfull"
"rssi"
(num)
<state>
0
(P)
[1]
Notes
•
Due to its restrictive range of values, there are events when it is not entirely clear from the context, which
event has led to the output of indicator "call". Rather than as an information in itself, indicator "call" should
therefore be used as a trigger to look up the new call status in the list of current calls with AT commands
,
or
AT^SLCC
AT+CLCC
•
If
setting
AT^SCFG
<succ>
lished, or when a call enters states "terminating" or "dropped" (see chapter
In these cases, the relevant information about the cause of the display is available only from AT command
.
AT^SLCC
•
The indicator "sounder" signals every event a tone is generated in the ME. For instance, if a waiting call pro-
duces a tone, this will be indicated.
•
If the ME is switched on all indicators are in registered state.
•
Use
command to allow Indicator Event Report of all registered indicators.
AT+CMER
Example
^SYSSTART
AT+CPIN=9999
OK
AT+CIND?
+CIND: 5,99,1,0,0,0,0,0,5
OK
AT+CMER=2,0,0,2
OK
MC55_ATC_V01.05
Confidential / Released
"unknown") occurs in the list of active calls or when a traffic channel is
established, if
AT^SCFG
Also refer
Call Status Information
Roaming indicator (0-1)
0: Registered to home network or not registered
1: Registered to other network
A short message memory storage in the MT has become full (1) or memory
locations are available (0), i.e. range is (0-1)
Received signal (field) strength (0..5) or (99) if not measurable.
0: signal strength <= -112 dbm
1-4: signal strength in 15 dbm steps
5: signal strength >= -51 dbm
Received signal (field) strength can also be obtained with
the signal strength is scaled to value range 0..31 by this command.
Indicator is deregistered. The indicator will not be presented as "
but can be queried with
Indicator is registered, indicator event report allowed.
.
AT^SCNI
="verbose", indicator "call" will be issued also when a traffic channel is estab-
The battery is either full or no battery is connected to the ME. The bit
error rate of the signal quality is not available (since there is no call in
progress). The ME is registered to its home network.
Now activate the Indicator Event Report with
Page 68 of 469
setting
="verbose".
<succ>
.
?.
AT+CIND
Call Status Information
s
m
obile
. However,
AT+CSQ
" URC,
+CIEV
.
AT+CMER
2/10/04
).
Advertisement
Table of Contents
