Ats7 Set Number Of Seconds To Wait For Connection Completion - Siemens MC55 Command Set

MC55 AT Command Set
7.13 ATS7
7.13

ATS7 Set number of seconds to wait for connection completion

Syntax
Read Command
ATS7?
Response(s)
<n>
OK
Write Command
ATS7=<n>
Response(s)
OK
PIN ASC0 ASC1 MUX1
! % !
Reference(s)
V.25ter
Command Description
This parameter setting determines the amount of time to wait for the connection completion when answering or
originating a call.
Parameter Description
(num)(&W)(&V)
<n>
no. of seconds to wait for connection completion
(&F)
000...060
Notes
• Values bigger than 60 cause no error, but
• In of of the called party is set to higher values the call establishment may not be successful.
<n> ATS0
• The correlation between
Example: ATS7=30 and ATS0=20 may not allow call establishment.
MC55_ATC_V01.05
Confidential / Released
MUX2 MUX3
% ! !
will be set down to maximum value of 60.
<n>
and is important.
ATS7 ATS0
Page 156 of 469
s
m
obile
2/10/04