Table of Contents
Advertisement
MC55 AT Command Set
10.18 ATS0
10.18
ATS0 Automatic response to a network request for PDP context
activation
Syntax
Read Command
ATS0?
Response(s)
<n>
OK
Write Command
ATS0=<n>
Response(s)
OK
PIN
ASC0
ASC1
MUX1
§
%
%
Reference(s)
GSM 07.07
Command Description
The V.25ter
=
(Automatic answer) command may be used to turn off (n=0) and on (n>0) the automatic
ATS0
<n>
response to a network request for a PDP context activation.
When the
=
(
ATS0
<n>
<n>
yet attached and if ME is configured to do this (see
being returned to the TE. Subsequently, the MT will announce a network request for PDP context activation by
issuing the URC RING or CRING to the TE, followed by the intermediate result code CONNECT. The MT then
enters V.25ter online data state and follows the same procedure as it would after having received a
command with no
<L2P>
=0 does not perform an automatic GPRS detach.
ATS0
Parameter Description
(num)(&W)(&V)
<n>
(&F)
000
001-255
Notes
•
If different settings are used on each interface, and a request for PDP context activation is received, the inter-
face 'wins' which is idle and uses the smallest
MC55_ATC_V01.05
Confidential / Released
MUX2
MUX3
%
%
%
> 0) command is received, the MT will attempt to perform a GPRS attach if it is not
or
values specified.
<cid>
automatic answering is disabled
enable automatic answering on the specified ring number
ATS0
Page 276 of 469
, parameter
AT^SCFG
<gaa>
value.
s
m
obile
). Failure will result in ERROR
AT+CGANS
2/10/04
=1
Advertisement
Table of Contents
