Attaching Cables & Wires - AMX Optima AVS-OP-1616-110 Instruction Manual

Attaching Cables & Wires
When attaching cables and input wires, refer to the sheet labeled "AutoPatch Optima Connector Guide"
that shipped with the system. The sheet shows where to attach the cables and wires. Follow the sheet
exactly; the system was programmed to operate only as indicated on the sheet. For multi-enclosure
systems, each enclosure will be numbered (e.g., "Chassis 1 of 3") on a label located on the left side
(near the power receptacle).
HD-15 Connectors
To connect HD-15 inputs:
1.
Fasten the cables onto the input HD-15 connectors (FIG. 102).
FIG. 102
Fasten cable onto HD-15 connector
HD-15 Board Connector Pinout
Pinout information for the High Density HD-15 connector on the RGBHV+Stereo to CatPro I/O board is
provided with FIG. 103.
FIG. 103
Pinout for I/O board HD-15 connector
Optima Instruction Manual
RGBHV+Stereo to CatPro Input/Output Boards
RGBHV+Stereo to CatPro I/O Board
HD-15 Connector Pinout
Input (VESA DDC Compliant)
1. Red 6. Red GND
2. Green 7. Green GND
3. Blue 8. Blue GND
4. ID Bit 9. +5 VDC in DDC 14. Vertical sync
5. GND 10. GNC
11. ID Bit
12. DDC SDA
13. Horizontal sync
15. DDC SCL
135