Table of Contents
Advertisement
Rack Installation & System Setup
The Epica DG Distribution Matrix enclosure is mounted in a standard EIA 19 in. (48.26 cm) rack.
Placing an Epica DG in a rack requires a minimum of three people.
Important: The system requires at least one empty rack unit above and below the enclosure to allow
adequate airflow; three empty rack units are recommended.
Required items for rack installation:
Installation Procedure
The following is a list of installation recommendations:
Caution: To prevent overheating and airflow restriction, avoid placing high heat producing
equipment directly above or below the enclosure. The system requires a minimum of one empty rack
unit above and below (three empty rack units are recommended). Verify that the openings on the
sides of the enclosure are not blocked and do not have restricted air flow.
Epica DG Instruction Manual
Enclosure(s)
Standard EIA 19 in. (48.26 cm) rack
Pallet jack or forklift
Screwdriver
Screws that fit your rack for mounting the enclosure(s)
Power cords
Surge-protector(s) – highly recommended
A PC or laptop computer with a null modem cable (for communication with the Epica DG via
the RS-232 serial port)
Write the serial number (normally located on rear of enclosure) in an easily accessible location
before installing the Epica DG in a rack.
Use an earth-grounded power cord / system with the Epica DG.
Attach all power cords to a single surge protector and/or an AC line conditioner.
Apply power to the Epica DG enclosure(s) before applying power to its source
and destination devices.
Installation & Setup
17
Advertisement
Table of Contents
