Table of Contents
Advertisement
Installing the Tinted Acrylic Door (Option 915)
Parts List
Quantity
Procedure
242 Rack Mounting and Option Installation
This procedure describes how to install the Tinted Acrylic Door on the HP
E840xA mainframe. The door requires the Standard Adapter Kit (p/n
E8400-80923), and is compatible with either the support rail kit (HP
E3664A) or the rack slide kit (p/n 1494-0411).
The parts included in Option 915 are shown in Table B-4.
Table B-4. HP E840xA Option 915 Parts List.
Description
1
Acrylic Door Assembly
2
Hinges
1
Door Latch, Lock, and Keys
2
Rubber Door Stops
4
Screws - m5x10 flat head
4
Screws - m3x8 pan head
Note
The door requires the mainframe to be recess mounted a minimum of
111 mm (4.36") or up to a maximum of 270.7 mm (10.6 inches) to
accommodate wiring terminals on the VXI instruments. When using the
minimum recess distance, field wiring cables must enter/exit the
instruments through the top and/or bottom openings only.
1. Recess mount the mainframe a minimum of 111 mm
(4.36 inches) using the Standard Adapter kit and either the support
rail kit (
Note
For the minimum recess distance, attach the rack mount adapters to the
mainframe beginning with the 12th hole from the front of the adapter.
2. If necessary, remove the dress screws (0570-1577) securing the
adapters to the rack.
3. Attach the hinge pins to the right rack mount adapter using four
m5x10 flat head screws (Figure B-12). Attach the rubber door stops
and door latch to the left adapter using four m3x8 pan head screws as
also shown in Figure B-12.
page 231
) or rack slide kit (
Part Number
E8400-09301
3110-0409
1390-0891
0403-0002
0515-1020
0515-0897
page 235
).
Appendix B
Advertisement
Table of Contents
