Table of Contents
Advertisement
Rack Rear
Stationary Section
Figure B-8. Removing the Rack Slide Chassis Section from the Intermediate Section.
m5x12 flat head screws
(Standard Adapter Kit)
238 Rack Mounting and Option Installation
5. Remove the chassis section from the intermediate section (Figure
B-88). (The chassis section will be connected to the mainframe in
Step 7.) Slide the intermediate section back into the stationary
section.
(Right Rack Slide Shown)
6. Attach the stationary section to the rack's front inside rail through the
channel nuts. Use two m5x12 flat head screws. Attach the stationary
section to the rear inside rail using two m5x12 pan-head screws
(Figure B-9).
Mounting Holes When Using
the VXI Plug&Play Compliant Adapters
Rack Front
(Left Rack Slide Shown)
Figure B-9. Installing the Rack Slide Stationary Sections.
7. Attach the rack mount adapters to the mainframe using the eight
m5x8 pan head screws provided. To mount the mainframe flush with
the rack front, begin with the 3rd hole from the front of the adapter
(Figure B-10).
The mainframe can be recess mounted up to 270.7 mm (10.6 inches)
in approximately 12.3 mm (1/2 inch) increments. Note that in some
recess positions, the front screw attaching the rack slide adapter may
have to be removed.
Depress From Back
Rack Front
Side To Remove
Stationary Section
Chassis Section
Rack Rear
m5x12 Pan Head Screws
(Standard Adapter Kit)
Appendix B
Advertisement
Table of Contents
