Test:sense - HP E8402A User And Service Manual

TEST:SENSe?

Returned Data
Comments
Error Conditions
Reset Condition
Related
Commands
164 Programming the Enhanced Monitor
performs a test of the A/D, D/A, and multiplexers in the enhanced
TEST:SENSe?
monitor. The command returns an integer; refer to TEST:ALL? for a complete list
of test failure messages.
Type Range
int16 -32767 to 32767 Result of test. +0 is a successful test. Refer to TEST:ALL? for a
•
interrupts the monitoring function of the enhanced monitor.
TEST:SENSe?
Measurement levels returned from other commands during a test routine were
all measured before the test routine started.
The following table lists the most common error conditions and causes. Error
numbers and corresponding messages can be found using
Number Message
-221 "Settings Conflict"
*RST aborts any TEST being performed.
*TST?, TEST:ALL?, TEST:MEM?, TEST:TEMP?, TEST:DISP?, TEST:BLOW?,
TEST:TIMe?
Description
complete list of test failure messages.
The mainframe's power is off.
SYSTem:ERRor?
Probable Cause
Chapter 3
query.