LED status
Flashing yellow
Off
NOTE:
The 1/10GBase-T port LEDs are not affected by the port mode
switching button on your switch. For more information about the
port mode switching button, see the installation guide of the
switch.
▌Installing and removing an interface card
CAUTION:
• Before you install or remove an interface card, wear an ESD
wrist strap and make sure the wrist strap makes good skin
contact and is reliably grounded.
• To avoid device damage, do not use excessive force when you
install or remove an interface card.
This example describes how to install and remove LSWM2XGT2PM
interface card on an HPE 5510 24G 4SFP+ HI 1-slot Switch
(JH145A).
Prepare the following tools before you install or remove an interface
card:
•
Phillips screwdriver.
•
Flat blade screwdriver.
•
ESD wrist strap.
The installation tools are not provided with HPE devices. Prepare
them yourself.
Installing an interface card
Removing a filler panel
1. Use the Phillips screwdriver to remove the screw on the filler
panel in the target interface card slot, as shown by callout 1
in
Figure
2.
Description
The port is sending or receiving data at 1 Gbps.
No link is present on the port.
3