Attaching The Stand; Adjusting The Stand; Installing The Stand - HP t628 Troubleshooting Manual

Attaching the stand

CAUTION:
mounted using the HP Quick Release mounting bracket.

Adjusting the stand

The stand included with the thin client allows the thin client to be used in either a tower or horizontal
orientation.
Take the stand apart by removing the two short pieces connecting the two sides. Snap the sides to the outer
connection points on the short pieces for a square configuration or to the inner connection points for the
narrow configuration.

Installing the stand

The stand included with the thin client allows the thin client to be used in either a tower or horizontal
orientation.
1. Remove/disengage any security devices that prohibit opening the thin client.
2. Remove all removable media, such as USB flash drives, from the thin client.
3. Turn off the thin client properly through the operating system, and then turn off any external devices.
4. Unplug the power cord from the AC outlet and disconnect any external devices.
5. Adjust the stand, if necessary.
For instructions, see
6. Attach the stand to the thin client.
● To use the thin client in the tower orientation:
a.
b.
c.
6 Chapter 2 Setup
To ensure proper airflow, the thin client must either be operated with the stand attached or be
Adjusting the stand on page
Position the thin client upside down and locate the two screw holes in the grid on the bottom
of the thin client.
Position the stand over the bottom of the thin client and line up the captive screws in the
stand with the screw holes in the thin client.
Tighten the captive screws securely.
6.