Table of Contents
Advertisement
*ESE <mask>
*ESE?
Parameter
Returned Data
Reset Condition
Related
Commands
174 Programming the Enhanced Monitor
*ESE <mask> command sets the value of the enable register in the Standard Event
status group.
*ESE? query returns the value of the enable register in the Standard Event status
group.
The standard event status group provides the status of common instrument events
including synchronization (Operation Complete) and Errors (Parser, Execution,
Command Errors, and Instrument Dependent).
The enable register specifies which bits in the event register can generate a summary
bit. The instrument logically ANDs corresponding bits in the event and enable
registers, and ORs all the resulting bits to obtain a summary bit. Summary bits are,
in turn, recorded in another register. The standard event status summary bit is
recorded in the Status Byte. Enable registers are read-write. Enable registers are not
affected by *CLS (Clear status). Querying enable registers does not affect them.
The following table describes each bit in the Standard Event status group:
Bit
0
Operation Complete (OPC)
1
Request Control (RQC)
2
Query Error (QYE)
3
Instrument Dependent (DDE)
4
Execution Error (EXE)
5
Command Error (CME)
6
User Request (URQ)
7
Power On (PON)
Name
Type
Range
< mask >
int16
0 - 255
Type Range Default
int16
0 - 255
none
*RST resets register the last value saved by the SYST:NVS command.
STATus:OPERation:ENABle, STATus:QUEStionable:ENABle, *ESE?
Description
Default
none
Bit mask indicating which enable bits are set (1)
or cleared (0) for the Standard Event status
group.
Description
Bit mask indicating which enable bits are set (1) or cleared (0)
for the Standard Event status group.
Decimal Value
1
2
4
8
16
32
64
128
Description
Chapter 3
Advertisement
Table of Contents
