Status:questionable:voltage:ptr <Mask> Status:questionable:voltage:ptr - HP E8402A User And Service Manual

STATus:QUEStionable:VOLTage:PTR < mask >
STATus:QUEStionable:VOLTage:PTR?
Parameters
Returned Data
Comments
Chapter 3
The
STATus:QUEStionable:VOLTage:PTR
The
STATus:QUEStionable:VOLTage:PTR?
voltage positive transition filter.
Only bit 3 and bit 4 of the transition filter can be set or cleared by the user.
Name Type Range
< mask > int16
0 to 32767
Type Range Default
int16 0 to 32767 none
•
If *PSC was set to 0 prior to power-down, then at power-on, the enable
registers are loaded from non-volatile memory. Therefore, any values that you
have stored (
SYSTem:NVSave
However, if *PSC was set to 1, then at power-on the factory defaults are
returned.
•
The following table describes the bits in the VOLTage status group:
Bit
0 +24 (P24) volt power supply
1 +12 (P12) volt power supply
2 +5 (P5) volt power supply
3 5Volt Standby
4 External 5 volt supply for
Enhanced Monitor RS-232 port.
5 -2 (N2) volt power supply
6 -5.2 (N5P2) volt power supply
7 -12 (N12) volt power supply
8 -24 (N24) volt power supply
9
10
11
12
13
14
15
sets the voltage positive transition filter.
returns an integer representing the
Default
511 Indicates the transition direction when an
(see comment event will occur.
below)
Description
Indicates the transition direction when an event will occur.
command) are returned to the registers.
Description
Unused
Unused
Unused
Unused
Unused
Unused
Unused
Programming the Enhanced Monitor
Description
Decimal Value
1
2
4
8
16
32
64
128
256
512
1024
2048
4096
8192
16384
32768
123