Status:questionable:condition - HP E8402A User And Service Manual

STATus:QUEStionable:CONDition?

Comments
Returned Data
Reset Condition
Related
Commands
100 Programming the Enhanced Monitor
The
STATus:QUEStionable:CONDition?
contents of the condition register associated with the questionable data status group.
The condition register continuously monitors the hardware and firmware status of
the instrument. There is no latching or buffering for this register; it is updated in real
time. Condition registers are read-only.
The following table describes each bit in the QUEStionable status group:
Bit
0 VOLTage summary. While a "1", an event is occurring in the
VOLT:COND register.
1 CURRent summary. While a "1", an event is occurring in the
CURR:COND register.
2 Unused
3 POWer. While a "1", total power is over limit.
4 TEMPerature summary. While a "1", an event is occurring in the
TEMP:COND register.
5 Unused
6 Unused
7 Unused
8 CALibration. While a "1", the last temperature or voltage calibration
failed.
9 BLOWer summary. While a "1", an event is occurring in the
BLOW:COND register.
10 UMCounter. While a "1", the UMC counter expired.
11 Unused
12 Unused
13 Unused
14 Unexpected Parameter
15 Always Zero
•
For any of the summary bits to be set, an enabled bit in the corresponding
Event Register was set. Refer to Figure 3-1 for the relationship between event
registers and summary bits.
•
Events are latched. The condition that set a bit may have stopped occurring.
Type Range Default
int16 0 - 32767 none
*RST does not affect the status system.
STATus:QUEStionable:EVENt?, STATus:QUEStionable:ENABle
query returns an integer representing the
Description
Description
Bit mask indicating which conditions are set (1) or cleared (0)
for the QUEStionable status group.
Decimal
Value
1
2
4
8
16
32
64
128
256
512
1024
2048
4096
8192
16384
32768
Chapter 3