Installing The Backplane Connector Shields; Parts List; Procedure - HP E8402A User And Service Manual

Installing the Backplane Connector Shields

WARNING

Parts List

Procedure

246 Rack Mounting and Option Installation
This procedure describes how to install backplane connector shields
(kit p/n E8400-80918 in the HP E840xA mainframe. The shields are HP's
implementation of VXI revision 1.4, specification B.7.2.3 which ensures
compliance with RFI levels specified in standards EN55011 and CISPR11.
Note
A number of VXI instruments require shields for compliance with
EN55011 and CISPR11. Refer to the instrument documentation to
determine if shields are required.
Do not install backplane connector shields while the mainframe
is turned on or plugged into an AC power source.
The parts included in the E8400-80918 kit are shown in Table B-6.
Quantity
54*
26
* Includes two extra screws
1. Position the shields over the backplane connectors as shown in Figure
B-14. Two connector shields and four screws are required for each
slot.
Table B-6. HP E8400-80918 Parts List.
Description
Torx Head Screw - 4-20x.25
Backplane Connector Shield
Part Number
0624-0702
E1400-80601
Appendix B