Removing the Rear
Panel from the
Mainframe
Figure 5-1. Removing / Replacing the Mainframe Rear Panel
Chapter 5
For most service work, you will need to remove the rear panel from the
mainframe. Figure 5-1 shows the procedure.
1. Remove the 14 screws from the rear panel.
2. The rear panel hinges at it top; rotate the panel upward. Pull the panel
out from the mainframe.
3. To replace the panel, insert the three tabs into the slots at the top of
the mainframe. Rotate the panel down until it is flush against the
mainframe. Replace all 14 screws.
(HP E8404 shown, HP E8402 is similar)
Servicing Your Mainframe 207