System:power:status - HP E8402A User And Service Manual

SYSTem:POWer:STATus?

Returned Data
Comments
Reset Condition
Related
Commands
154 Programming the Enhanced Monitor
SYSTem:POWer:STATus?
sources of power-up/power-down assertion. The three sources are the front panel
ON/STDBY switch, the diagnostic connector's remote power lines, and the
SYSTem:POWer command.
Type
<switch>
unit16n
< auxRemote > unit16
< software > unit16
The mainframe cannot power-off unless ALL three of these states are 0 (zero).
*RST has no effect on this query.
SYSTem:POWer
returns three integers representing the status of the three
Range Default
0, 1 none This indicates the front panel switch state. 1
indicates it is pushed in (power-on).
0, 1 none The state of the Diagnostic connector's
remote power signal. 1 indicates it is
connected to the remote power signal return.
Refer to "Using the Remote Power-On Pins"
on page 25 and "Diagnostic Connector" on
page 42
0, 1 none The state of the software power-on
command (SYSTem:POW ON/OFF). 1
indicates that a software power-on command
is active.
Description
Chapter 3