Status:questionable:enable <Mask> Status:questionable:enable - HP E8402A User And Service Manual

Vxi c-size mainframe
Table of Contents

Advertisement

STATus:QUEStionable:ENABle < mask >
STATus:QUEStionable:ENABle?
Parameters
Returned Data
Comments
Error Conditions
Reset Condition
Related
Commands
106 Programming the Enhanced Monitor
The
STATus:QUEStionable:ENABle
for the questionable status group.
The
STATus:QUEStionable:ENABle?
of the enable register for the questionable status group.
The enable register specifies which bits in the event register can generate a summary
bit. The instrument logically ANDs corresponding bits in the event and enable
registers, and ORs all the resulting bits to obtain a summary bit. Summary bits are,
in turn, recorded in another register. The questionable status summary bit is recorded
in the Status Byte. Enable registers are read-write. Enable registers are not affected
by *CLS (Clear status). Querying enable registers does not affect them.
Name
Type
Range
< mask >
int16
0 - 32767
Type
Range
int16
0 - 32767
Refer to
STATus:QUEStionable:CONDition?
QUEStionable status group.
If *PSC was set to 0 prior to power-down, then at power-on, the enable
registers are loaded from non-volatile memory. Therefore, any values that you
have stored (SYSTem:NVSave command) are returned to the registers.
However, if *PSC was set to 1, then at power-on the factory defaults are
returned.
The following table lists the most common error conditions and causes. Error
numbers and corresponding messages can be found using
Number
Message
-222
"Data out of range"
*RST resets register the last value saved by the SYST:NVS command. Use
to clear the enable registers of the OPERation status group and the
STATus:PRESet
QUEStionable status group.
STATus:QUEStionable:CONDition?, STATus:QUEStionable:EVENt?,
STATus:PRESet, SYSTem:NVSave, *PSC
command sets the value of the enable register
query returns an integer representing the value
Default
0
(see 2nd
comment below)
Description
mask value.
The < mask > value is invalid.
Description
Bit mask for the enable register of the
QUEStionable status group.
for a description of each bit in the
SYSTem:ERRor?
Probable Cause
query.
Chapter 3

Advertisement

Table of Contents
loading

This manual is also suitable for:

E8404a

Table of Contents