Table of Contents
Advertisement
SYSTem:BEEPer:FREQuency < frequency >
SYSTem:BEEPer:FREQuency? [MIN | MAX]
Parameters
Returned Data
Comment
Reset Condition
Related
Commands
Chapter 3
SYSTem:BEEPer:FREQuency
SYSTem:BEEPer:IMMediate
SYSTem:NVSave
command to save the frequency in non-volatile memory.
SYSTem:BEEPer:FREQuency?
beeper.
Name
Type
< frequency >
int16
enum
Type
Range
int16
125 - 6000
Beeper Frequency.
•
The frequency is used by
the mainframe.
•
If you specify a <frequency> out side of the valid boundaries (125 to 6000), the
actual frequency is clamped to the closest valid value; no error is generated.
For example, if you specify <frequency> as 10000, it is clamped at 6000.
Similarly, if you specify 100, it is clamped at 125.
*RST returns the beeper frequency to the last values saved by the SYST:NVS
command.
SYSTem:BEEPer:TIME, SYSTem:NVSave
<frequency> sets the frequency of the beeper for the
command and mainframe warnings. Use the
returns an integer representing the frequency of the
Range
Default
125 - 6000
1000
MIN, MAX, DEF
MIN, MAX
Description
SYSTem:BEEP:IMM
Programming the Enhanced Monitor
Description
Frequency of beep, in Hertz
Returns minimum and maximum
frequency for beeper.
and by warning conditions in
127
Advertisement
Table of Contents
