Psc *Psc - HP E8402A User And Service Manual

*PSC
*PSC?
Parameters
Returned Data
Comments
Error Conditions
Reset Condition
Related
Commands
178 Programming the Enhanced Monitor
*PSC command sets/clears the power-on status clear flag.
*PSC? returns the power-on status clear flag.
Type Range
boolean 0-1
Type Range
int16 0 - 255
•
If *PSC was set to 0 prior to power-down, then at power-on, the enable
registers are loaded from non-volatile memory. Therefore, any values that you
have stored (SYSTem:NVSave command) are returned to the registers.
However, if *PSC was set to 1, then at power-on the factory defaults are
returned. The factory defaults are listed in the following table:
STATus:OPERation:ENABle
STATus:QUEStionable:ENABle
STAT:QUES:BLOWer:ENABle
STAT:QUES:CURRent:ENABle
STAT:QUES:TEMPerature:ENABle
STAT:QUES:VOLT:ENABle
STAT:QUES:VOLT:PTR
The following table lists the most common error conditions and causes. Error
numbers and corresponding messages can be found using
Number Message
-222 "Settings Conflict"
*RST resets register the last value saved by the SYST:NVS command.
SYSTem:NVSave
Default
1 Sets/clears the PSC flag
Default
none Status of Power-on clear flag.
Register
Mainframe power is off.
Description
Description
Default
Value
0
0
7
487
32767
487
511
SYSTem:ERRor? query.
Probable Cause
Chapter 3