Table of Contents
Advertisement
STATus:QUEStionable:CURRent:LEVel? <supply>[,MIN|MAX]
Parameters
Returned Data
Comments
Error conditions
Reset Condition
Related
Commands
104 Programming the Enhanced Monitor
The
STATus:QUEStionable:CURRent:LEVel?
representing the last measurement of the power supply current in Amps.
Name
Type
< supply >
enum.
P24, P12, P5,
N2, N5P2, N12,
N24
optional
optional
MIN, MAX
parameter
enum.
Type
Range
float32
•
This command is not supported for all power supplies. When current
measurement is supported, the measurement returned is the last measurement
made on the supply identified with <param>. Under normal operation, this
should be within the last 2 seconds. Current is not measured during a *TST? or
CAL? operation, so a query to
measurement made before the long operation was entered. If the power of the
mainframe is off, this query will return the last measurement made before
power turned off.
•
The optional MIN and MAX parameter allows the power supply's current
limits to be queried. For Example,
the limit warning point for the 5V supply.
The following table lists the most common error conditions and causes. Error
numbers and corresponding messages can be found using
Number
Message
-241
"Hardware missing"
*RST does not affect the status system.
STATus:QUEStionable:CURRent:EVENt?,
STATus:QUEStionable:CURRent:CONDition?,
STATus:QUEStionable:CURRent:ENABle?,
STATus:QUEStionable:CURRent:ENABle
query returns a floating number
Range
Default
none
Indicates which power supply current is
being queried. P5 is positive 5 Vdc
supply, N12 is negative 12 Vdc supply,
etc.
none
When added after <param> , returns the
maximum and minimum current limits.
Default
none
Power-supply current in Amps.
STAT:QUES:CURR:LEV?
STAT:QUES:CURR:LEV? P5,MAX
Power supply doesn't support current
measurements
Description
Description
will return the last
returns
query.
SYSTem:ERRor?
Probable Cause
Chapter 3
Advertisement
Table of Contents
