Rack Mounting The Hp E840Xa Using Support Rails; Procedure - HP E8402A User And Service Manual

Rack Mounting the
HP E840xA using
Support Rails

Procedure

Figure B-1. Attaching Handles to the Adapters (Option 923 - kit p/n E8400-80923).
Appendix B
This section contains instructions for mounting the HP E840xA mainframe
in an EIA cabinet using the HP E3664A support rail kit. The E3664A kit can
be used with any of the rack mount adapter options; however, the E3664A
is only compatible with HP cabinets. The following procedures apply to all
adapters, with adapter-specific information noted where necessary.
Note
If you ordered Cable Tray Option 914, refer to
tray before rack mounting the mainframe.
1. Attach the handles to the adapters using the m5x10 flat head screws
(Figure B-1). Handles are included only with the HP E840xA
Standard adapters (Option 923).
2. Using the rack mount adapters as templates, position the adapters on
the rack's vertical rails where the mainframe is to be mounted. Align
the adapter holes over the "center" holes of the EIA rack units (Figure
B-2).
Note
If you are using the HP E840xA VXIplug&play Compliant adapters
(Option 925), position the adapters such that all three mounting holes are
directly over holes on the rack's vertical rails, and that the adapter flanges
cover nine full EIA rack units with no overlap.
m5x10 Flat Head Screws
Rack Mounting and Option Installation
page 240
and install the
231