When 1U Ac Outlet Box Is Installed - Fujitsu Eternus2000 Manual

4.2.6.2 With an AC Outlet Box
The following explains how to connect the power cord when an AC outlet box is installed.
The following explains how to connect the power cord to 1U or 4U AC outlet box.

When 1U AC outlet box is installed

The procedure to connect the power cord to 1U AC outlet box is as follows:
1
Remove the power cord clamps from the AC outlet box.
AC outlet box
2
Connect the AC outlet box outlets and power unit inlets with power cord (AC out-
put cables) (3m).
The procedures to connect the power unit is the same as the
Box" (page
The following table and figure show the connection path of an AC outlet cable and connection fig-
ure respectively
Table 4.1
Connection source
(AC outlet box outlet)
The first ACS
The second ACS
The third ACS
The fourth ACS
P3AM-2512-03EN ETERNUS2000 disk storage system User Guide
77).
Connection path of a power cord (AC output cable)
(AC outlet box (1U))
OUTPUT #0 - 1
OUTPUT #0 - 2
OUTPUT #1 - 1
OUTPUT #1 - 2
OUTPUT #0 - 1
OUTPUT #0 - 2
OUTPUT #1 - 1
OUTPUT #1 - 2
OUTPUT #0 - 1
OUTPUT #0 - 2
OUTPUT #1 - 1
OUTPUT #1 - 2
OUTPUT #0 - 1
OUTPUT #0 - 2
OUTPUT #1 - 1
OUTPUT #1 - 2
Copyright 2009 FUJITSU LIMITED
power cord clamps
Step 1 in "4.2.6.1 With No AC Outlet
Connection distribution
(power unit inlet)
Controller enclosure PSU#0 inlet
Drive enclosure 1 PSU#0 inlet
Controller enclosure PSU#1 inlet
Drive enclosure 1 PSU#1 inlet
Drive enclosure 2 PSU#0 inlet
Drive enclosure 3 PSU#0 inlet
Drive enclosure 2 PSU#1 inlet
Drive enclosure 3 PSU#1 inlet
Drive enclosure 4 PSU#0 inlet
Drive enclosure 5 PSU#0 inlet
Drive enclosure 4 PSU#1 inlet
Drive enclosure 5 PSU#1 inlet
Drive enclosure 6 PSU#0 inlet
Drive enclosure 7 PSU#0 inlet
Drive enclosure 6 PSU#1 inlet
Drive enclosure 7 PSU#1 inlet
Chapter 4 Setup
4
79