Lan Cable Connection (Twisted Pair Cable Compatible With Enhanced Category 5) (Iscsi Type) - Fujitsu Eternus2000 Manual

3
Connect the Fibre Channel cables to the server or the Fibre Channel switch.
Connect the other end of the Fibre Channel cable to the Fibre Channel adapter of the server or the
Fibre Channel switch.
4.2.3 LAN Cable Connection (Twisted Pair Cable Compatible with Enhanced
Category 5) (iSCSI Type)
Connect the ETERNUS2000 and the server or Fibre Channel switch with a LAN cable (twisted pair cable
compatible with Enhanced Category 5).
A 5m LAN cable is supplied for each iSCSI port.
IMPORTANT
CAUTION
P3AM-2512-03EN ETERNUS2000 disk storage system User Guide
Do
CAUTION
• When connecting the Fibre Channel cables, position them so
that they will not obstruct replacement of the power supply unit
or controllers by the maintenance engineer.
• Separate the LAN used for iSCSI connection from other LAN.
• Operation mode of iSCSI is Full Duplex (FULL).
• When connecting to a server via switching hub, use the switching hub
that supports 1Gbps.
Do
• Before starting, make sure to attach a wrist strap or touch the metal
frame of the device to eliminate static electricity. Failure to discharge
static electricity may cause device failure.
• When connecting external (signal, power, etc.) cables, avoid pulling
them as it may cause damage.
Do Not
• Do not bend the cable too much or bind it up. Doing so may cause a
device damage or failure.
90
Do not bend square
Copyright 2009 FUJITSU LIMITED
Do not bind up
Chapter 4 Setup
4
67