Fujitsu Eternus2000 Manual page 112

4.3 ETERNUS2000 Setup
Network settings for the PC to be used
Perform the following procedure to setup the PC to be used for setting up the ETERNUS2000.
1
2
3
4
88
Connect the PC to the MNT port of the ETERNUS2000 Controller 0 (CM#0)
directly with a LAN cable (twist pair cable compatible with Category 5) (for oper-
ation management).
When a LAN cable (twist pair cable compatible with Category 5) (for operation management) is
connected to Controller 1 (CM#1), disconnect it.
Set the IP address and subnet mask of the PC.
Set the following values.
IP address: 192.168.1.2
Subnet mask: 255.255.255.0
Set the web browser to not use a proxy server and a cache (Temporary Internet
Files).
Turn on the ETERNUS2000.
• When turning on the ETERNUS2000 for the first time, volume
IMPORTANT
• When stopping a volume formatting operation, delete the vol-
• When checking the connection between PC used for setup and
Point
the ETERNUS2000, execute the "ping" command at the PC com-
mand prompt.
The following is an example of ping execution: ("192.168.1.1" is
the default IP address)
If the execution results in error, check the PC's network settings.
• If communication fails even though the MNT port of controller 0
(CM#0) and the LAN port of the PC are connected, check that
MASTER LED of controller 0 (CM#0) is lit. If the MASTER LED of
controller 1 (CM#1) is lit, use the MNT port of controller 1 (CM#1).
Copyright 2009 FUJITSU LIMITED
formatting operation, which is set as factory default, may be
performed. However, the ETERNUS2000 setting operation
can be continued.
u m e . F o r d e t a i l s o n d e l e t i n g a v o l u m e , r e f e r t o
"ETERNUS2000 ETERNUSmgr User Guide -Setting/Mainte-
nance-.
ping 192.168.1.1
ETERNUS2000 disk storage system User Guide P3AM-2512-03EN